1. Non-standard chain of brush The smooth low-speed category (ν< 1 m / s) can be used in the high-speed category (ν> 5 m / s) by using a nylon brush to apply the speed between the two brushes. However, when high speed (ν > 10 m / s) is required to force smoothing to take warm cooling, the temperature should not exceed 70 °C.
2. Drip smooth non-standard chain and chain speed, the speed is reduced by about 5 to 20 drops per minute, and the high speed drops more. Be careful not to deviate from the oil droplets, and don't just push out the chain of the oil droplet center, as it can't be used with smooth non-standard chain joint areas. I want to smooth the appearance of the pin and roll side plates in the oil drop.
3 is shown. The diameter of the oil bath smooth oil pan or oil pan should be sufficient to incubate the rolling speed of 3.3 ~ 4.5 m / s. Chain and 25 mm wide, sprocket loaded on both sides of the board.
4 is shown. When the oil is smooth, the inner chain of the oil and the chain plate ring should be added, just for the symmetry of the chain loosening in the width direction of the petroleum chain.